[NSRCA-discussion] YS help

[billglaze]

Small size pulley/gear pullers are available in most well stocked auto parts places that sell tools.  I've used mine many a time in different applications.
  ----- Original Message ----- 
  From: Bob Kane 
  To: nsrca-discussion at lists.nsrca.org 
  Sent: Friday, July 04, 2008 5:39 PM
  Subject: [NSRCA-discussion] YS help


  Well, for all the YS engines I have rebuilt, I'm stuck with a situation I have not run into before. I dissassembled 160DZ to replace the main bearing. The 2nd to the last step in the dissassembly porcess is to remove the crank. A few light taps and it normally slides out. Well, this time the bearing stayed on the crank. Usually it stays in the crankcase. Normally I would heat the cranckcase to get the bearing to fall out, but how do you get a stuck bearing off the crank? The fully circular rear face of the crank shaft makes getting to the bearing difficult.  Suggestions?
   
  Bob Kane
  getterflash at yahoo.com 




------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20080704/8af9c005/attachment.html>