[NSRCA-discussion] YS help

[Bob Kane]

Well, for all the YS engines I have rebuilt, I'm stuck with a situation I have not run into before. I dissassembled 160DZ to replace the main bearing. The 2nd to the last step in the dissassembly porcess is to remove the crank. A few light taps and it normally slides out. Well, this time the bearing stayed on the crank. Usually it stays in the crankcase. Normally I would heat the cranckcase to get the bearing to fall out, but how do you get a stuck bearing off the crank? The fully circular rear face of the crank shaft makes getting to the bearing difficult.  Suggestions?
 Bob Kane
getterflash at yahoo.com


      
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20080704/0256d866/attachment.html>