[NSRCA-discussion] Elevator alignment jig photo

[Jim Houck]

For some reason, I don't get the images I just get <file.jpg>.

On Sat, May 11, 2019 at 9:04 PM Jas S via NSRCA-discussion <
nsrca-discussion at lists.nsrca.org> wrote:

> Perfect Kevin, thank you 👍
>
> Jas iP
>
> > On May 11, 2019, at 9:36 PM, KEVIN DUNCAN <duncanbp at msn.com> wrote:
> >
> > Not sure if this is what you're looking for, but this is the jig I use
> to keep my elevator straight with the stab.  It came with my Episode kit.
> I cut it and attached braces so I can lay it over the stab without removing
> the servo and linkages.
> >
> > Hope this helps,
> > Kevin
> >
> > -----Original Message-----
> > From: NSRCA-discussion <nsrca-discussion-bounces at lists.nsrca.org> On
> Behalf Of Jas S via NSRCA-discussion
> > Sent: Saturday, May 11, 2019 6:14 PM
> > To: nsrca-discussion at lists.nsrca.org
> > Subject: [NSRCA-discussion] Elevator alignment jig photo
> >
> > Does anyone have a picture of a ‘jig’, or sleeve, that goes over the
> stab/elevator for checking incidence they can send me please. Basically the
> airfoil cut out of a piece of lite-ply that slides over the stab to keep
> the elevator aligned with the stab.
> >
> > Thank you
> >
> > Jas iP
> > _______________________________________________
> > NSRCA-discussion mailing list
> > NSRCA-discussion at lists.nsrca.org
> > http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> > <Jig.pdf>
> > <IMG_3423.JPG>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion



-- 
Thanks

Jim R Houck
Cell: 512-947-5032
AMA 22622
FAA FA3TWMW49W
FCC KG5ZMZ
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20190512/3c22d909/attachment.html>