[NSRCA-discussion] Elevator alignment jig photo

[Jas S]

Perfect Kevin, thank you 👍

Jas iP

> On May 11, 2019, at 9:36 PM, KEVIN DUNCAN <duncanbp at msn.com> wrote:
> 
> Not sure if this is what you're looking for, but this is the jig I use to keep my elevator straight with the stab.  It came with my Episode kit.  I cut it and attached braces so I can lay it over the stab without removing the servo and linkages.
> 
> Hope this helps,
> Kevin
> 
> -----Original Message-----
> From: NSRCA-discussion <nsrca-discussion-bounces at lists.nsrca.org> On Behalf Of Jas S via NSRCA-discussion
> Sent: Saturday, May 11, 2019 6:14 PM
> To: nsrca-discussion at lists.nsrca.org
> Subject: [NSRCA-discussion] Elevator alignment jig photo
> 
> Does anyone have a picture of a ‘jig’, or sleeve, that goes over the stab/elevator for checking incidence they can send me please. Basically the airfoil cut out of a piece of lite-ply that slides over the stab to keep the elevator aligned with the stab.
> 
> Thank you
> 
> Jas iP
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> <Jig.pdf>
> <IMG_3423.JPG>