[NSRCA-discussion] Fw: Jeti/Mezon endpoints settings?

[edskorepa at yahoo.com]

   ----- Forwarded Message ----- From: "edskorepa at yahoo.com" <edskorepa at yahoo.com>To: Jas S <justanotherflyr at gmail.com>Sent: Thursday, November 8, 2018, 11:43:33 AM MSTSubject: Re: [NSRCA-discussion] Jeti/Mezon endpoints settings?
  Go to a servo monitor. Well, they don't call it monitor. Main Menu > System > Rx Outputs. Change it to mSec and start plying.

   On Thursday, November 8, 2018, 11:23:59 AM MST, Jas S via NSRCA-discussion <nsrca-discussion at lists.nsrca.org> wrote: 
 
 Hi Jim,

Where in the Tx will I find these settings?

Thanks,
Jason 
Jas iP

> On Nov 8, 2018, at 11:49 AM, James Oddino <joddino at me.com> wrote:
> 
> Anything you want.  I set mine to fixed, 1.1 mSec on the low end and 2.0 mSec on the high end.  Then set the transmitter throttle channel to the same numbers.  Then trim the low end for a good idle.  You may need to jog the throttle to start the motor but you want to have it idle when you pull it all the way down.  Don’t forget to set the fail safe.  I set that at .95 mSec.  If you set up a brake you set it just slightly below 1.1 mSec.
> 
> Note that you can read all of these settings on the Jeti transmitter.  Easy to set up.  Pretty neat.
> 
> Jim
> 
>> On Nov 8, 2018, at 8:17 AM, Jas S via NSRCA-discussion <nsrca-discussion at lists.nsrca.org> wrote:
>> 
>> What are the endpoints I need to set the Mezon for a Jeti radio?
>> 
>> Thanks 
>> _______________________________________________
>> NSRCA-discussion mailing list
>> NSRCA-discussion at lists.nsrca.org
>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> 
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion  

|  | Virus-free. www.avg.com  |

  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20181108/b2fb7920/attachment.html>