[NSRCA-discussion] Jeti/Mezon endpoints settings?

[James Oddino]

I didn’t watch the whole video, but I believe it does a good job of showing the method of setting the Mezon with the Jeti Box and then shows you how to access the Jeti Box emulator in the transmitter.  To see your transmitter settings, go to Menu>System>Receiver Output.  Here you will see the output of each channel in percentages.  If you press the center button below the display you can cycle the readings to give you Milliseconds.  Use the normal Dual rate/ Expo menu to set the end points and read them on the Receiver output menu.  Hope this helps.  

Sounds like you are going after Bruckmann.  There are some other tricks in the Jeti Radio so holler if you need help.

Jim

> On Nov 8, 2018, at 10:23 AM, Jas S <justanotherflyr at gmail.com> wrote:
> 
> Hi Jim,
> 
> Where in the Tx will I find these settings?
> 
> Thanks,
> Jason 
> Jas iP
> 
>> On Nov 8, 2018, at 11:49 AM, James Oddino <joddino at me.com> wrote:
>> 
>> Anything you want.  I set mine to fixed, 1.1 mSec on the low end and 2.0 mSec on the high end.  Then set the transmitter throttle channel to the same numbers.  Then trim the low end for a good idle.  You may need to jog the throttle to start the motor but you want to have it idle when you pull it all the way down.  Don’t forget to set the fail safe.  I set that at .95 mSec.  If you set up a brake you set it just slightly below 1.1 mSec.
>> 
>> Note that you can read all of these settings on the Jeti transmitter.  Easy to set up.  Pretty neat.
>> 
>> Jim
>> 
>>> On Nov 8, 2018, at 8:17 AM, Jas S via NSRCA-discussion <nsrca-discussion at lists.nsrca.org> wrote:
>>> 
>>> What are the endpoints I need to set the Mezon for a Jeti radio?
>>> 
>>> Thanks 
>>> _______________________________________________
>>> NSRCA-discussion mailing list
>>> NSRCA-discussion at lists.nsrca.org
>>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>