[NSRCA-discussion] Jeti/Mezon endpoints settings?

[lucky macy]

Start at minute 7 for how do this in general from the TX.

https://youtu.be/OOK4S2cRWe8

On Nov 8, 2018, at 1:24 PM, Jas S via NSRCA-discussion <nsrca-discussion at lists.nsrca.org<mailto:nsrca-discussion at lists.nsrca.org>> wrote:

Hi Jim,

Where in the Tx will I find these settings?

Thanks,
Jason
Jas iP

On Nov 8, 2018, at 11:49 AM, James Oddino <joddino at me.com<mailto:joddino at me.com>> wrote:

Anything you want.  I set mine to fixed, 1.1 mSec on the low end and 2.0 mSec on the high end.  Then set the transmitter throttle channel to the same numbers.  Then trim the low end for a good idle.  You may need to jog the throttle to start the motor but you want to have it idle when you pull it all the way down.  Don’t forget to set the fail safe.  I set that at .95 mSec.  If you set up a brake you set it just slightly below 1.1 mSec.

Note that you can read all of these settings on the Jeti transmitter.  Easy to set up.  Pretty neat.

Jim

On Nov 8, 2018, at 8:17 AM, Jas S via NSRCA-discussion <nsrca-discussion at lists.nsrca.org<mailto:nsrca-discussion at lists.nsrca.org>> wrote:

What are the endpoints I need to set the Mezon for a Jeti radio?

Thanks
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org<mailto:NSRCA-discussion at lists.nsrca.org>
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org<mailto:NSRCA-discussion at lists.nsrca.org>
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20181108/37338318/attachment.html>