[NSRCA-discussion] Castle settings

[Olstinske Dale]

V4.22, Low timing but is set on Outrunner Mode not 8khz…could that be it?  Not sure why but thought I had read that the Advance works best in this mode? 
Will check if that fixes it as soon as I can.
Dale



> On Nov 1, 2017, at 1:35 PM, DaveL322 <DaveL322 at comcast.net> wrote:
> 
> What are the other settings? 
> 
> Specifically check - 
> Software is 4.22, or higher
> Low timing
> 8khz pwm
> 
> And.... All solder joints and connectors are healthy. 
> 
> Possibly try reloading software...not likely to help, but it might. 
> 
> Regards,
> 
> Dave
> 
> Sent from my Sprint Samsung Galaxy Note5.
> 
> -------- Original message --------
> From: Olstinske Dale via NSRCA-discussion <nsrca-discussion at lists.nsrca.org>
> Date: 11/1/17 3:59 PM (GMT-05:00)
> To: General pattern discussion <nsrca-discussion at lists.nsrca.org>
> Subject: [NSRCA-discussion] Castle settings
> 
> I have an Edge 80 HV Esc, Plettenberg Advance motor. I usually need around 70-75 A to get good performance, but I can’t get more than 60A from this one. I’ve recalibrate the throttle (fixed end points) but no improvement. Wondering if there is some other setting causing this?
> 
> Thanks,
> 
> Dale
> 
> 
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20171101/989b7dab/attachment.html>