[NSRCA-discussion] Castle settings

[S. McNickle]

Maybe I should let Mark Atwood speak for himself, but he's kinda busy right now...

Mark told me he tried everything he could think of and couldn't get a Pletty Advance to run full power on a Castle ESC. He recommended the Jetti or O.S.  I got the O.S. and it works fine.


Scott

>     On November 1, 2017 at 5:51 PM Olstinske Dale via NSRCA-discussion <nsrca-discussion at lists.nsrca.org> wrote:
> 
>     V4.22, Low timing but is set on Outrunner Mode not 8khz…could that be it?  Not sure why but thought I had read that the Advance works best in this mode? 
>     Will check if that fixes it as soon as I can.
>     Dale
> 
> 
> 
> 
>         > >         On Nov 1, 2017, at 1:35 PM, DaveL322 <DaveL322 at comcast.net mailto:DaveL322 at comcast.net > wrote:
> > 
> >         What are the other settings? 
> > 
> >         Specifically check - 
> >         Software is 4.22, or higher
> >         Low timing
> >         8khz pwm
> > 
> >         And.... All solder joints and connectors are healthy. 
> > 
> >         Possibly try reloading software...not likely to help, but it might. 
> > 
> >         Regards,
> > 
> >         Dave
> > 
> >         Sent from my Sprint Samsung Galaxy Note5.
> > 
> >         -------- Original message --------
> >         From: Olstinske Dale via NSRCA-discussion <nsrca-discussion at lists.nsrca.org mailto:nsrca-discussion at lists.nsrca.org >
> >         Date: 11/1/17 3:59 PM (GMT-05:00)
> >         To: General pattern discussion <nsrca-discussion at lists.nsrca.org mailto:nsrca-discussion at lists.nsrca.org >
> >         Subject: [NSRCA-discussion] Castle settings
> > 
> >         I have an Edge 80 HV Esc, Plettenberg Advance motor. I usually need around 70-75 A to get good performance, but I can’t get more than 60A from this one. I’ve recalibrate the throttle (fixed end points) but no improvement. Wondering if there is some other setting causing this?
> > 
> >         Thanks,
> > 
> >         Dale
> > 
> > 
> >         _______________________________________________
> >         NSRCA-discussion mailing list
> >         NSRCA-discussion at lists.nsrca.org mailto:NSRCA-discussion at lists.nsrca.org
> >         http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> > 
> >     > 
> 


 

> _______________________________________________
>     NSRCA-discussion mailing list
>     NSRCA-discussion at lists.nsrca.org
>     http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20171101/1502e139/attachment.html>