[NSRCA-discussion] Main battery redundant lead for receiver

[Keith Hoard]

Only tap off two cells of your main pack. You can then use a regular regulator (as opposed to a non-regular regulator). 

Keith Hoard
Collierville, TN

On Jan 23, 2012, at 16:49, Peter Vogel <vogel.peter at gmail.com> wrote:

> And, of course, with a non-switching BEC off a 10s or even a 5s pack you would have massive heat issues as it tries to step down the voltage from 18.5 volts to 7.2 or 6 volts, depending on whether you are running an HV or standard voltage setup, so the regulator would probably need a fan or heat sink of some sort, which likely negates any weight savings from not running with a second battery.
> 
> Peter+
> 
> On Mon, Jan 23, 2012 at 2:30 PM, Scott McHarg <scmcharg at gmail.com> wrote:
> You have to be careful using the BEC, especially from CC because it is a switching regulator which cannot be run in parallel.  It's really best not to use the BEC and set up a truly separate system.
> 
> Scott
> 
> 
> On Mon, Jan 23, 2012 at 4:28 PM, George Kennie <geobet4evr at gmail.com> wrote:
> Could a CC BEC also be used instead of a reg.? I don't know how much curent is passed by a reg.
> Sounds good cause it's a bummer trying to solder an extra lead to the Deans.
>  
> G.
> 
> On Mon, Jan 23, 2012 at 5:09 PM, Scott McHarg <scmcharg at gmail.com> wrote:
> Guys,
>    Chris Moon just e-mailed me about some leads that were done at the factory.  These leads run off your balance leads to a voltage regulator and allow your main battery pack to be utilized as a redundant receiver battery.  It is NOT meant to be a primary but it will save 20+ grams if you're running 2 rx batteries.  You still have to run the 2nd regulator for true redundancy but you eliminate the 2nd battery.  These leads are factory made and eliminate the need to make them yourself with the concern about plugging in to the wrong cell.  I know in my article, I was pretty much against doing this as a backup but, with Chris having this made at the factory, he has all but eliminated making a mistake by tying to the wrong cell.  I have the link that I'll e-mail you off-list or you can just go to his website.  I don't want to break the NSRCA list rules by advertising for him even though he advertises with the NSRCA.  The leads are only $3.99 each and are found under the Connectors/Adapters listing.
> 
> Thank,
> Scott
> 
> -- 
> Scott A. McHarg
> 
> 
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> 
> 
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> 
> 
> 
> -- 
> Scott A. McHarg
> 
> 
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> 
> 
> 
> -- 
> Director, Fixed Wing Flight Training
> Santa Clara County Model Aircraft Skypark
> 
> 
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20120123/1a42d62f/attachment.html>