[NSRCA-discussion] Need a little help with ICE HV80 setup

[Ed White]

In a new E-motion I've got a Pletty Xtra 30-10, ICE HV 80, 20.5x14 PT models CF 
prop.  The problem I have is that I have it set on the ground for about 65 amps 
WOT.  According to the logger I'm exceeding 100 amps in the air and triggering 
the current cutoff.  I can hear the cutoff operate in the air.  But I do not get 
an error code.  Firmware is the latest.  Settings.are below.  


Should I just expect peaks over 100 amps? and set the current limiting to 
insensitive?  Or is there something else I need to look for?  Also, although PWM 
is set to 8 KHz, I also tried OUTRUNNER and got pretty much the same result, a 
little less hitting the cutoff.

thanks,

Ed

#######################################################
# Castle Link Data File
# Created: Monday, June 13, 2011
# Do Not Edit This File By Hand
#######################################################
Hex55: 85
Brake Delay: .3s
Brake Ramp: Slow
Cutoff Type: Soft Cutoff
Motor Start Power: 39
Direction: Forward (*)
Brake Strength: 30
PWM Rate: 8 Khz
Cutoff Voltage: 300
Current Limiting: Sensitive (100A)
Sample Frequency: 1 Sample / Sec (*)
Power-On Beep: Enabled (*)
Auto-Lipo Volts/Cell: 3.0 Volts/Cell
Motor Timing: 0
Data Log Enabled: 253
Vehicle Type: Airplane
Throttle Type: Fixed-Endpoints
Throttle Response: 5
Governor Gain: 15
Initial Spool-Up Rate: 5
Head Speed Change Rate: 5
Auto Rotate Enabled: False
Governor Mode Type: Simple
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20110614/930ef08b/attachment.html>