<html><head><style type="text/css"><!-- DIV {margin:0px;} --></style></head><body><div style="font-family:arial,helvetica,sans-serif;font-size:10pt">In a new E-motion I've got a Pletty Xtra 30-10, ICE HV 80, 20.5x14 PT models CF prop. The problem I have is that I have it set on the ground for about 65 amps WOT. According to the logger I'm exceeding 100 amps in the air and triggering the current cutoff. I can hear the cutoff operate in the air. But I do not get an error code. Firmware is the latest. Settings.are below. <br><br>Should I just expect peaks over 100 amps? and set the current limiting to insensitive? Or is there something else I need to look for? Also, although PWM is set to 8 KHz, I also tried OUTRUNNER and got pretty much the same result, a little less hitting the cutoff.<br><br>thanks,<br><br>Ed<br><br>#######################################################<br># Castle Link Data
File<br># Created: Monday, June 13, 2011<br># Do Not Edit This File By Hand<br>#######################################################<br>Hex55: 85<br>Brake Delay: .3s<br>Brake Ramp: Slow<br>Cutoff Type: Soft Cutoff<br>Motor Start Power: 39<br>Direction: Forward (*)<br>Brake Strength: 30<br>PWM Rate: 8 Khz<br>Cutoff Voltage: 300<br>Current Limiting: Sensitive (100A)<br>Sample Frequency: 1 Sample / Sec (*)<br>Power-On Beep: Enabled (*)<br>Auto-Lipo Volts/Cell: 3.0 Volts/Cell<br>Motor Timing: 0<br>Data Log Enabled: 253<br>Vehicle Type: Airplane<br>Throttle Type: Fixed-Endpoints<br>Throttle Response: 5<br>Governor Gain: 15<br>Initial Spool-Up Rate: 5<br>Head Speed Change Rate: 5<br>Auto Rotate Enabled: False<br>Governor Mode Type: Simple<br><br></div></body></html>