[NSRCA-discussion] Need Dremel Part

[scott at rcfoamy.com]

Ron,

I had the same issue and found a piece of stiff vinyl type tubing at home depot that fit and made the coupler out of that.... It has works great.

Scott A.
Sent from my Verizon Wireless BlackBerry

-----Original Message-----
From: Ron Van Putte <vanputte at cox.net>
Sender: nsrca-discussion-bounces at lists.nsrca.org
Date: Tue, 6 Jul 2010 13:57:58 
To: General pattern discussion<nsrca-discussion at lists.nsrca.org>
Reply-To: General pattern discussion <nsrca-discussion at lists.nsrca.org>
Subject: [NSRCA-discussion] Need Dremel Part

I have an old Dremel Freewheeler Model 850 that has a flexible  
coupler between the motor and the output shaft.  This coupler is  
splined on the inside and the splines finally wore out after 20+  
years for no reason at all.  It's on its third or fourth battery  
pack, but still worked fine before the coupler gave out. I've tried  
searching sources for Dremel parts but can't find what I need.  I  
would just buy a new one, but I am stubborn and the son of a Scottish  
mother, who would rise up out of her grave if I did.

Any ideas?

Ron Van Putte 
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion