[NSRCA-discussion] Need Dremel Part

[Ron Van Putte]

Thanks!

Ron

On Jul 6, 2010, at 2:07 PM, scott at rcfoamy.com wrote:

> Ron,
>
> I had the same issue and found a piece of stiff vinyl type tubing  
> at home depot that fit and made the coupler out of that.... It has  
> works great.
>
> Scott A.
> Sent from my Verizon Wireless BlackBerry
>
> -----Original Message-----
> From: Ron Van Putte <vanputte at cox.net>
> Sender: nsrca-discussion-bounces at lists.nsrca.org
> Date: Tue, 6 Jul 2010 13:57:58
> To: General pattern discussion<nsrca-discussion at lists.nsrca.org>
> Reply-To: General pattern discussion <nsrca- 
> discussion at lists.nsrca.org>
> Subject: [NSRCA-discussion] Need Dremel Part
>
> I have an old Dremel Freewheeler Model 850 that has a flexible
> coupler between the motor and the output shaft.  This coupler is
> splined on the inside and the splines finally wore out after 20+
> years for no reason at all.  It's on its third or fourth battery
> pack, but still worked fine before the coupler gave out. I've tried
> searching sources for Dremel parts but can't find what I need.  I
> would just buy a new one, but I am stubborn and the son of a Scottish
> mother, who would rise up out of her grave if I did.
>
> Any ideas?
>
> Ron Van Putte
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion