[NSRCA-discussion] PPG Concept Paint Qs

[mike mueller]

 Thanks for sharing that Lance. It makes sense. Mike Mueller

--- On Thu, 12/24/09, patterndude at tx.rr.com <patterndude at tx.rr.com> wrote:

> From: patterndude at tx.rr.com <patterndude at tx.rr.com>
> Subject: Re: [NSRCA-discussion] PPG Concept Paint Qs
> To: "General pattern discussion" <nsrca-discussion at lists.nsrca.org>
> Date: Thursday, December 24, 2009, 11:42 AM
> I agree with Tim, especially the fact
> that a near constant temp will minimise air
> expansion/contraction and slow the spoilage.  but I
> would add that I've had real good results with a trick that
> can be used on anything where air and moisture are a
> problem. Get a can of "wine preserver". Its just a can of
> compressed nitrogen with a straw applicator. N is heavier
> than air so a layer quickly sprayed in the can before
> capping will isolatr the material. It works for half empty
> fuel jugs, paint, and of course wine. Also, I keep the seal
> clean and add a layer of saran plastic wrap under the cap to
> improve the seal. 
>    Using this I've kept hardeners for at
> least 2 seasons without spoilage. Might be longer but I buy
> the smallest cans available and usually use it up by then
> 
> Hope that helps
> 
> Lance
> Sent via BlackBerry by AT&T
> 
> -----Original Message-----
> From: tbruzewski at aol.com
> Date: Thu, 24 Dec 2009 11:55:57 
> To: <nsrca-discussion at lists.nsrca.org>
> Subject: Re: [NSRCA-discussion] PPG Concept Paint Qs
> 
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>