[NSRCA-discussion] Futaba R6014FS Receivers

[James Oddino]

The JR servos I tested worked down to about 1.2 volts but the buffer  
amps required about 2.7 volts so they are a on the ragged edge.

Jim


On Nov 20, 2008, at 7:15 PM, MKMSG wrote:

> I was reading the FAQ section of the Futaba website when a  
> particular item caught my eye regarding the R6014FS 2.4 receiver.   
> The FAQ states that the use of non Futaba digital servos with the  
> R6014FS receiver may be problematic due to the 6014's lower output  
> voltage of 2.7 volts.  Since I do occasionally mix and match Futaba  
> and JR servos and use the 8 channel 2.4 receiver, I wondered if this  
> issue was common to all Futaba 2.4 receivers.  Here's Futaba's  
> answer: "The FAQ refers only to the R6014FS receiver, this is the  
> only one that has the lower voltage."  Just thought I'd pass this  
> along in case someone experiences performance anomalies with the  
> 6014 receivers using other than Futaba servos.
>
> Mike
> NSRCA 35
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20081121/536230b3/attachment.html>