[NSRCA-discussion] Embarrassing Programming Problem

[Tony]

Ron:
This is due to the elevator stick pot being slightly out of alignment.  It
will have to be serviced to fix this problem.


Tony Stillman, President
Radio South, Inc.
139 Altama Connector, Box 322
Brunswick, GA  31525
1-800-962-7802
www.radiosouthrc.com

-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Ron Van Putte
Sent: Monday, May 05, 2008 5:39 PM
To: General pattern discussion
Subject: Re: [NSRCA-discussion] Embarrassing Programming Problem

OK.  I caved and went with ailevator.  I nulled out the aileron  
inputs and everything works as it should, EXCEPT I'm still getting a  
small neutral shift on both elevators (same direction) when moving  
the elevator dual rate switch.

Ron

On May 5, 2008, at 3:20 PM, Tony wrote:

> Ron:
> Why are you re-inventing the wheel?
> Use the Ailvator pre-set mix for dual elevator servos already built  
> into the
> 9Z..
>
>
> Tony Stillman, President
> Radio South, Inc.
> 139 Altama Connector, Box 322
> Brunswick, GA  31525
> 1-800-962-7802
> www.radiosouthrc.com
>
> -----Original Message-----
> From: nsrca-discussion-bounces at lists.nsrca.org
> [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Ron  
> Van Putte
> Sent: Monday, May 05, 2008 4:09 PM
> To: General pattern discussion
> Subject: [NSRCA-discussion] Embarrassing Programming Problem
>
> I'm setting up a new airplane on my Futaba 9ZAP transmitter and using
> channels 2 and 6 for servos on each elevator half.  I have PMX set
> for channels 2 and 6, mixing channel 2 into channel 6 and everything
> works fine, except the servo on channel 6 only moves about 2/3 the
> throw of the servo on channel 2.  I've tried everything I can think
> of to rectify the problem with no success.  In addition, there's a
> small shift in neutral when going from high rate elevator to low rate.
>
> I started with an unused model in the menu, so I don't think there's
> any hidden programming lurking.
>
> Any ideas?  I'll be very irritated to find there's a simple solution,
> but I'd also be very grateful to have the problem go away.
>
> Ron Van Putte
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion