[NSRCA-discussion] Embarrassing Programming Problem

[Karl G. Mueller]

Ron,

I know how you feel. I been trying to setup "Crow" on an
Ultrastick with separate ailerons and flaps on the 9ZAW.
Following the instructions step by step from the Futaba website
I just can't seem to get it to work right. Also followed instruction 
from 2 other sources, still no success. Ready to give up.

Karl G. Mueller
kgamueller at rogers.com

----- Original Message ----- 
From: "Ron Van Putte" <vanputte at cox.net>
To: "General pattern discussion" <nsrca-discussion at lists.nsrca.org>
Sent: Monday, May 05, 2008 4:08 PM
Subject: [NSRCA-discussion] Embarrassing Programming Problem


> I'm setting up a new airplane on my Futaba 9ZAP transmitter and using  
> channels 2 and 6 for servos on each elevator half.  I have PMX set  
> for channels 2 and 6, mixing channel 2 into channel 6 and everything  
> works fine, except the servo on channel 6 only moves about 2/3 the  
> throw of the servo on channel 2.  I've tried everything I can think  
> of to rectify the problem with no success.  In addition, there's a  
> small shift in neutral when going from high rate elevator to low rate.
> 
> I started with an unused model in the menu, so I don't think there's  
> any hidden programming lurking.
> 
> Any ideas?  I'll be very irritated to find there's a simple solution,  
> but I'd also be very grateful to have the problem go away.
> 
> Ron Van Putte
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>