[NSRCA-discussion] Embarrassing Programming Problem

[Verne Koester]

Ron,
Are you actually using dual rates within the same flight condition with the 
switch or getting the dual rate by going to a different flight condition? If 
you're going to a different flight condition, then the problem could be 
different trim settings or a different rate of trim on the second flight 
condition. It helps to remember that a flight condition is essentially a 
whole new model and almost EVERYTHING can be changed. Your subtrims could be 
the problem as well. Hope this helps.

Verne


----- Original Message ----- 
From: "Ron Van Putte" <vanputte at cox.net>
To: "General pattern discussion" <nsrca-discussion at lists.nsrca.org>
Sent: Monday, May 05, 2008 5:38 PM
Subject: Re: [NSRCA-discussion] Embarrassing Programming Problem


> OK.  I caved and went with ailevator.  I nulled out the aileron
> inputs and everything works as it should, EXCEPT I'm still getting a
> small neutral shift on both elevators (same direction) when moving
> the elevator dual rate switch.
>
> Ron
>
> On May 5, 2008, at 3:20 PM, Tony wrote:
>
>> Ron:
>> Why are you re-inventing the wheel?
>> Use the Ailvator pre-set mix for dual elevator servos already built
>> into the
>> 9Z..
>>
>>
>> Tony Stillman, President
>> Radio South, Inc.
>> 139 Altama Connector, Box 322
>> Brunswick, GA  31525
>> 1-800-962-7802
>> www.radiosouthrc.com
>>
>> -----Original Message-----
>> From: nsrca-discussion-bounces at lists.nsrca.org
>> [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Ron
>> Van Putte
>> Sent: Monday, May 05, 2008 4:09 PM
>> To: General pattern discussion
>> Subject: [NSRCA-discussion] Embarrassing Programming Problem
>>
>> I'm setting up a new airplane on my Futaba 9ZAP transmitter and using
>> channels 2 and 6 for servos on each elevator half.  I have PMX set
>> for channels 2 and 6, mixing channel 2 into channel 6 and everything
>> works fine, except the servo on channel 6 only moves about 2/3 the
>> throw of the servo on channel 2.  I've tried everything I can think
>> of to rectify the problem with no success.  In addition, there's a
>> small shift in neutral when going from high rate elevator to low rate.
>>
>> I started with an unused model in the menu, so I don't think there's
>> any hidden programming lurking.
>>
>> Any ideas?  I'll be very irritated to find there's a simple solution,
>> but I'd also be very grateful to have the problem go away.
>>
>> Ron Van Putte
>> _______________________________________________
>> NSRCA-discussion mailing list
>> NSRCA-discussion at lists.nsrca.org
>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>
>> _______________________________________________
>> NSRCA-discussion mailing list
>> NSRCA-discussion at lists.nsrca.org
>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>