[NSRCA-discussion] Embarrassing Programming Problem

[Rex]

Ron
 
Check  your trim memories on the main screen...  flip the dual rate switches as you watch the trim 
position indicator.  If it moves, then you need to reset the trim memories....  My old 9Z had a 
habit of doing exactly what you are describing.  I would have to reset them every now and then
 
Rex



> From: vanputte at cox.net> Date: Mon, 5 May 2008 16:38:51 -0500> To: nsrca-discussion at lists.nsrca.org> Subject: Re: [NSRCA-discussion] Embarrassing Programming Problem> > OK. I caved and went with ailevator. I nulled out the aileron > inputs and everything works as it should, EXCEPT I'm still getting a > small neutral shift on both elevators (same direction) when moving > the elevator dual rate switch.> > Ron> > On May 5, 2008, at 3:20 PM, Tony wrote:> > > Ron:> > Why are you re-inventing the wheel?> > Use the Ailvator pre-set mix for dual elevator servos already built > > into the> > 9Z..> >> >> > Tony Stillman, President> > Radio South, Inc.> > 139 Altama Connector, Box 322> > Brunswick, GA 31525> > > > www.radiosouthrc.com> >> > -----Original Message-----> > From: nsrca-discussion-bounces at lists.nsrca.org> > [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Ron > > Van Putte> > Sent: Monday, May 05, 2008 4:09 PM> > To: General pattern discussion> > Subject: [NSRCA-discussion] Embarrassing Programming Problem> >> > I'm setting up a new airplane on my Futaba 9ZAP transmitter and using> > channels 2 and 6 for servos on each elevator half. I have PMX set> > for channels 2 and 6, mixing channel 2 into channel 6 and everything> > works fine, except the servo on channel 6 only moves about 2/3 the> > throw of the servo on channel 2. I've tried everything I can think> > of to rectify the problem with no success. In addition, there's a> > small shift in neutral when going from high rate elevator to low rate.> >> > I started with an unused model in the menu, so I don't think there's> > any hidden programming lurking.> >> > Any ideas? I'll be very irritated to find there's a simple solution,> > but I'd also be very grateful to have the problem go away.> >> > Ron Van Putte> > _______________________________________________> > NSRCA-discussion mailing list> > NSRCA-discussion at lists.nsrca.org> > http://lists.nsrca.org/mailman/listinfo/nsrca-discussion> >> > _______________________________________________> > NSRCA-discussion mailing list> > NSRCA-discussion at lists.nsrca.org> > http://lists.nsrca.org/mailman/listinfo/nsrca-discussion> > _______________________________________________> NSRCA-discussion mailing list> NSRCA-discussion at lists.nsrca.org> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20080505/6d1c4336/attachment.html