[NSRCA-discussion] Embarrassing Programming Problem

[Duane Beck]

Do you get the same shift if you reset the subtrims to 0 (make note of the original values first)?

Duane

-------------- Original message -------------- 
From: Ron Van Putte <vanputte at cox.net> 

> OK. I caved and went with ailevator. I nulled out the aileron 
> inputs and everything works as it should, EXCEPT I'm still getting a 
> small neutral shift on both elevators (same direction) when moving 
> the elevator dual rate switch. 
> 
> Ron 
> 
> On May 5, 2008, at 3:20 PM, Tony wrote: 
> 
> > Ron: 
> > Why are you re-inventing the wheel? 
> > Use the Ailvator pre-set mix for dual elevator servos already built 
> > into the 
> > 9Z.. 
> > 
> > 
> > Tony Stillman, President 
> > Radio South, Inc. 
> > 139 Altama Connector, Box 322 
> > Brunswick, GA 31525 
> > 1-800-962-7802 
> > www.radiosouthrc.com 
> > 
> > -----Original Message----- 
> > From: nsrca-discussion-bounces at lists.nsrca.org 
> > [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Ron 
> > Van Putte 
> > Sent: Monday, May 05, 2008 4:09 PM 
> > To: General pattern discussion 
> > Subject: [NSRCA-discussion] Embarrassing Programming Problem 
> > 
> > I'm setting up a new airplane on my Futaba 9ZAP transmitter and using 
> > channels 2 and 6 for servos on each elevator half. I have PMX set 
> > for channels 2 and 6, mixing channel 2 into channel 6 and everything 
> > works fine, except the servo on channel 6 only moves about 2/3 the 
> > throw of the servo on channel 2. I've tried everything I can think 
> > of to rectify the problem with no success. In addition, there's a 
> > small shift in neutral when going from high rate elevator to low rate. 
> > 
> > I started with an unused model in the menu, so I don't think there's 
> > any hidden programming lurking. 
> > 
> > Any ideas? I'll be very irritated to find there's a simple solution, 
> > but I'd also be very grateful to have the problem go away. 
> > 
> > Ron Van Putte 
> > _______________________________________________ 
> > NSRCA-discussion mailing list 
> > NSRCA-discussion at lists.nsrca.org 
> > http://lists.nsrca.org/mailman/listinfo/nsrca-discussion 
> > 
> > _______________________________________________ 
> > NSRCA-discussion mailing list 
> > NSRCA-discussion at lists.nsrca.org 
> > http://lists.nsrca.org/mailman/listinfo/nsrca-discussion 
> 
> _______________________________________________ 
> NSRCA-discussion mailing list 
> NSRCA-discussion at lists.nsrca.org 
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20080505/027124e0/attachment-0001.html