[NSRCA-discussion] O-Ring for Hatori Short Pipe

[Mark Atwood]

I¹ll need to measure again, but I was thinking the inner diameter needed to
be 15mm...




On 6/26/08 3:25 PM, "John Konneker" <jlkonn at hotmail.com> wrote:

> I just ordered some of these from McMaster Carr.  I should have them tomorrow.
> Maybe someone can comment if these are the ones to use.
> 9263K772 <http://www.mcmaster.com/nav/enter.asp?partnum=9263K772&pagenum=3390>
> Metric Viton O-Ring 3.5 mm Width, 16 mm ID, Packs of 10 (Same as 9263K11)
>  
>  
> 
> JLK
> 
>> 
>> Date: Thu, 26 Jun 2008 15:03:39 -0400
>> From: atwoodm at paragon-inc.com
>> To: nsrca-discussion at lists.nsrca.org
>> Subject: [NSRCA-discussion] O-Ring for Hatori Short Pipe
>> 
>>> Can someone direct me to a source (or several) for replacement o-rings to
>>> connect the Hatori 821 short pipe to the Hatori 822 header?  Central is out
>>> of the authentic Hatori O-rings and won¹t have more for a while.  Is there
>>> another source, or a suitable replacement available?
>>> 
>>> Thanks,
>>> 
>>> Mark
> 
> 
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20080626/f90b59cb/attachment.html>