[NSRCA-discussion] Aileron cut-off

[Mark Atwood]

What's the bottom of the wing look like?  Doesn't the blade end up cutting
pretty far past the end point on the bottom side?

Also, and this may just be me... But I use the shucks a LOT throughout the
building of the plane.  Both for keeping the wings from getting damaged, but
also for any drilling and sanding so as to hold the wing square.  I'd hate
to cut up my shuck at that stage.

I must say though, it looks like you get a very straight, very clean (and
I'm guessing VERY quick) cut.

-mark


On 1/30/08 9:58 PM, "J N Hiller" <jnhiller at earthlink.net> wrote:

> As promised last week, here is a photo showing how I cut ailerons etc. from
> sheeted foam core flying surfaces using a 10" table saw.
> The wing panel is positioned on top of a 1/4 x 14 x 36 plywood sheet with a
> key attached to the bottom that slides in the table grove.
> If anyone wants a full size photo let me know and I will send it direct.
> Jim Hiller
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion