[NSRCA-discussion] Rudder

[J N Hiller]

There is substantial fuselage side area behind the CG also.
Jim Hiller

-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org]On Behalf Of Jerry Voth
Sent: Wednesday, October 10, 2007 1:34 PM
To: NSRCA Mailing List
Subject: Re: [NSRCA-discussion] Rudder

I've been folloing this thread and there is one thing that puzzles me. The
vertical fin and rudder are (and I'm guessing) about 20% of the total side
area of a pattern plane. If it were weathervaning,why wouldn't the nose be
more prone to blow in the direction of the wind?


----- Original Message -----
From: Del K. Rykert <mailto:drykert2 at rochester.rr.com>
To: NSRCA Mailing List <mailto:nsrca-discussion at lists.nsrca.org>
Sent: Wednesday, October 10, 2007 2:23 PM
Subject: Re: [NSRCA-discussion] Rudder

Thank goodness judges don't have a T & B ball in a panel in front of them to
watch how many are skidding through the air.. grins..  I have always felt if
all things are pure the pattern airplane in true corrected crab maintains it
same speed when pulling to vertical and the crosswind component stays
constant then no further input is needed till your speed starts to decay
when pulling vertical.  What many are doing is flying one wing low when in
level fight then when they pull vertical have to sneak in some extra
correction for pulling a highly visible vertical to the judges.

    Del
----- Original Message -----
From: Woodward, Jim <mailto:jim.woodward at baesystems.com>
To: NSRCA Mailing List <mailto:nsrca-discussion at lists.nsrca.org>
Sent: Wednesday, October 10, 2007 1:31 PM
Subject: Re: [NSRCA-discussion] Rudder

Bob – the correct answer on using aileron during a radius, for the purpose
of wind correction, is that if you are NOT using it is a downgrade(able).
It’s impossible in every way to use only rudder through a radius actually
keep the “wings-level” to the intended flight path.
Maneuvers are to be wind-corrected and flown in a single vertical plane –
anything less is uncivilized :-)
The wings should be “level” at every part of the curve/radius, and the only
way to do that is by rolling the plane, slightly.
Thanks,
Jim W.
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Bob Richards
Sent: Wednesday, October 10, 2007 1:19 PM
To: NSRCA Mailing List
Subject: Re: [NSRCA-discussion] Rudder
That is the best description I have read so far. Agree 100%.
Not long ago, I was talking with someone about wind correction and mentioned
that a very small amount of aileron should be used when pulling a radius to
a vertical line. He said if he ever saw me do it while he was judging, he
would downgrade. I told him if I do it right, he will never see it. :-)
Bob R.


J N Hiller <jnhiller at earthlink.net> wrote:
This has been an interesting discussion. The airplane dose not establish a
crab angle on it’s own when in the air. The airplane has a crab angle in
horizontal flight and when it is pulled vertical the wings will not be
perpendicular to the flight path without a roll correction. The need for the
correction will be apparent and automatically applied prior to finishing the
radius. When a roll input is applied with elevator it changes the heading in
the direction of roll, (think barrel roll) in this case into the wind as it
finishes the radius. Most of the time it will be excessive requiring a
little opposite (down wind) rudder correction unless the upwind wing was
high entering the pull-up. Once the airplane is leaning to one side in a
vertical the lean will increase and is especially noticeable as it slows.
Some increase is needed to maintain wind correction and the need for
opposite rudder to maintain a vertical track depends on how rapidly the
airplane is decelerated. Most of the time I will try to apply some down wind
rudder with the roll correction at about 45 degrees, before the need becomes
visible as it is nearly always required. In short just point the airplane in
the direction you want it to go and stir the sticks as necessary.
Jim Hiller

CONFIDENTIALITY NOTICE: This e-mail message, including any attachments, is
for the sole use of the intended recipient(s) and may contain confidential
and proprietary information.  Any unauthorized review, use, disclosure or
distribution is prohibited.  If you are not the intended recipient(s),
please contact the sender by reply e-mail and destroy all copies of the
original message.

  _____

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
  _____

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20071010/9971b3ad/attachment-0001.html