[NSRCA-discussion] OS 120 Ax bearing replacement

[Ed Alt]

BTW, I buy these sealed bearings from a local supply house for abut $11.  Tower's prices are still a rip, though a bargain compared to Boca.

  ----- Original Message ----- 
  From: JonLowe at aol.com 
  To: nsrca-discussion at lists.nsrca.org 
  Sent: Wednesday, May 30, 2007 8:53 PM
  Subject: Re: [NSRCA-discussion] OS 120 Ax bearing replacement


  In a message dated 5/30/2007 8:35:05 PM Central Daylight Time, jpavlick at idseng.com writes:
    Has anyone replaced the bearings in their OS 120 Ax? What's the trick? I've done plenty of bearings but this one is different. After removing everything, including the sleeve, I can't slide the rod far enough back to get it off the crankpin. The pin boss in the piston is too narrow to allow the rod to slide far enough. If anyone has done this already I'd appreciate any insight. Thanks!

  John,
  I've done it.  The rod will slide far enough on the pin, but often sticks on baked on stuff that gets on the pin.  You have to work it back and forth until it frees up.  Try some WD-40 or something like that to try to melt away the crud.

  Use the 1.40  fuel injected rear bearing from Tower.  Cheaper than Boca, and it is much better than the original.  I only got about 30-40 flights on my 1.20 before I had to change the bearing.

  Jon Lowe






------------------------------------------------------------------------------
  See what's free at AOL.com. 


------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20070531/3e6fc552/attachment.html