[NSRCA-discussion] Controll Systems

[Michael Lance]

Here's the Horizon link:
http://www.horizonhobby.com/Products/Default.aspx?ProdId=KSJ1370

 

Are currently on back order status.

 

-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Rex LESHER
Sent: Thursday, January 11, 2007 7:29 PM
To: NSRCA Mailing List
Subject: Re: [NSRCA-discussion] Controll Systems

 

I believe they still have them, but now you have to find them in the
Helicopter section....

 

Rex

----- Original Message ----- 

From: jivey61 at bellsouth.net 

To: NSRCA Mailing List <mailto:nsrca-discussion at lists.nsrca.org>  

Sent: Thursday, January 11, 2007 7:22 PM

Subject: Re: [NSRCA-discussion] Controll Systems

 

Nat

 JR used to make a top bearing brace for the servos. It was a housing that
went over the top of the servo and had a adjustable rod to the back of the
servo connected to the brace.I use it on the rudder and it solves that
problem of top bearing wear. Iv'e had the same problem before due to cable
tension.

We need to see if they are still available or get them to make them again.

 

Jim Ivey

----- Original Message ----- 

From: Nat <mailto:natpenton at centurytel.net>  Penton 

To: NSRCA Mailing List <mailto:nsrca-discussion at lists.nsrca.org>  

Sent: Thursday, January 11, 2007 10:08 PM

Subject: [NSRCA-discussion] Controll Systems

 

I'm probably the originator of the .070 carbon-dep system - about 86.
Carbon/balsa fuses and kevlar/balsa fuses , are poor combinations, and I'm
still using them. Both systems are vulnerable to temp and/or humidity
changes and are a pain. Since I've been doing this since 86 I must be a slow
learner. No slop but sometimes a trim change every hour.

 

With balsa fuses, for elev, I plan to go (back) to a balsa dowell pushrod
and use a crossover ( MK, or custom ? ) just in front of the stab. Not sure
how to handle the rudder, two small hard balsa dowells ? I've had undue
kevlar tension ruin two DS8411sa servos on an electric.
Nat


  _____  


_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20070113/3edbb057/attachment.html