[NSRCA-discussion] Masters 2007 Figure "M" question

[dwaynenancy]

You should look at the Figure M in the Master's pattern of 25 years ago 
except it was done with half rolls.  The first maneuver other than take 
off and it set the whole quality of the flight.  Dwayne

jivey61 at bellsouth.net wrote:

>Jerry
>You are right I looked at the aresti again and the rolls are shown the same
>direction.
>Sorry Bob...my bad.Gotta get another crutch now.
>Jim Ivey
>----- Original Message ----- 
>From: "Jerry Budd" <jerry at buddengineering.com>
>To: "NSRCA Mailing List" <nsrca-discussion at lists.nsrca.org>
>Sent: Tuesday, October 17, 2006 12:19 PM
>Subject: Re: [NSRCA-discussion] Masters 2007 Figure "M" question
>
>
>  
>
>>Hi Jim,
>>
>>Unless the maneuver has changed from 15 years ago all the rolls have
>>to be in the same direction, resulting in one stall turn being
>>canopy-facing you and the other being belly-facing you (your choice
>>as to which comes first).  It's a tough maneuver, especially when the
>>wind is blowing other than down the runway.
>>
>>Jerry
>>
>>
>>    
>>
>>>Bob
>>> My memory crutch is,when flying from left to right, the 1st 2 roll
>>>directions are left-left and 2nd 2 roll directions are right-right.
>>>When flying from the right to left,the 1st 2 roll directions are
>>>      
>>>
>right-right
>  
>
>>>and 2nd 2 roll directions are left-left.
>>>Like Arch said the center half  loop is inverted in both cases.
>>>Lotsa a upside down.
>>>
>>>Jim Ivey
>>>
>>>----- Original Message -----
>>>From: "Archie Stafford" <rcpattern at stx.rr.com>
>>>To: "'NSRCA Mailing List'" <nsrca-discussion at lists.nsrca.org>
>>>Sent: Tuesday, October 17, 2006 11:11 AM
>>>Subject: Re: [NSRCA-discussion] Masters 2007 Figure "M" question
>>>
>>>
>>>      
>>>
>>>> Bob,
>>>>
>>>> It has to be inverted.  The direction of roll must be the same on
>>>>        
>>>>
>every
>  
>
>>>3/4
>>>      
>>>
>>>> roll therefore you end up inverted across the middle.
>>>>
>>>> Arch
>>>>
>>>> -----Original Message-----
>>>> From: nsrca-discussion-bounces at lists.nsrca.org
>>>> [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Bob
>>>>        
>>>>
>Kane
>  
>
>>>> Sent: Tuesday, October 17, 2006 9:53 AM
>>>> To: nsrca-discussion at lists.nsrca.org
>>>> Subject: [NSRCA-discussion] Masters 2007 Figure "M" question
>>>>
>>>> OK, I'm finally try to fly this thing with a pencil . . . . . .    one
>>>> question I have (so far) is the 1/2 loop between the two stall turns
>>>>        
>>>>
>in
>  
>
>>>the
>>>      
>>>
>>>> figure M: Does it matter if it is an inside or outside half loop?  The
>>>> aresti diagram posted on Flying Giants shows it as an outside half
>>>>        
>>>>
>loop
>  
>
>>>with
>>>      
>>>
>>>> no option.  Thanks.
>>>>
>>>> Bob Kane
>>>> getterflash at yahoo.com
>>>>
>>>>
>>>>
>>>> _______________________________________________
>>>> NSRCA-discussion mailing list
>>>> NSRCA-discussion at lists.nsrca.org
>>>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>>>
>>>> _______________________________________________
>>>> NSRCA-discussion mailing list
>>>> NSRCA-discussion at lists.nsrca.org
>>>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>>>        
>>>>
>>>_______________________________________________
>>>NSRCA-discussion mailing list
>>>NSRCA-discussion at lists.nsrca.org
>>>http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>>      
>>>
>>-- 
>>___________
>>Jerry Budd
>>Budd Engineering
>>(661) 722-5669 Voice/Fax
>>(661) 435-0358 Cell Phone
>>mailto:jerry at buddengineering.com
>>http://www.buddengineering.com
>>_______________________________________________
>>NSRCA-discussion mailing list
>>NSRCA-discussion at lists.nsrca.org
>>http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>    
>>
>
>_______________________________________________
>NSRCA-discussion mailing list
>NSRCA-discussion at lists.nsrca.org
>http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
>
>  
>