[NSRCA-discussion] Masters 2007 Figure "M" question

jivey61 at bellsouth.net jivey61 at bellsouth.net
Tue Oct 17 08:45:00 AKDT 2006


Jerry
 I looked again at the aresti and I think you are right.The aresti shows
both upline rolls in the same direction.That would let you see the top one
time and bottom the other time.
My mistake Bob so much for crutches.

Jim Ivey
----- Original Message ----- 
From: "Jerry Budd" <jerry at buddengineering.com>
To: "NSRCA Mailing List" <nsrca-discussion at lists.nsrca.org>
Sent: Tuesday, October 17, 2006 12:19 PM
Subject: Re: [NSRCA-discussion] Masters 2007 Figure "M" question


> Hi Jim,
>
> Unless the maneuver has changed from 15 years ago all the rolls have
> to be in the same direction, resulting in one stall turn being
> canopy-facing you and the other being belly-facing you (your choice
> as to which comes first).  It's a tough maneuver, especially when the
> wind is blowing other than down the runway.
>
> Jerry
>
>
> >Bob
> >  My memory crutch is,when flying from left to right, the 1st 2 roll
> >directions are left-left and 2nd 2 roll directions are right-right.
> >When flying from the right to left,the 1st 2 roll directions are
right-right
> >and 2nd 2 roll directions are left-left.
> >Like Arch said the center half  loop is inverted in both cases.
> >Lotsa a upside down.
> >
> >Jim Ivey
> >
> >----- Original Message -----
> >From: "Archie Stafford" <rcpattern at stx.rr.com>
> >To: "'NSRCA Mailing List'" <nsrca-discussion at lists.nsrca.org>
> >Sent: Tuesday, October 17, 2006 11:11 AM
> >Subject: Re: [NSRCA-discussion] Masters 2007 Figure "M" question
> >
> >
> >>  Bob,
> >>
> >>  It has to be inverted.  The direction of roll must be the same on
every
> >3/4
> >>  roll therefore you end up inverted across the middle.
> >>
> >>  Arch
> >>
> >>  -----Original Message-----
> >>  From: nsrca-discussion-bounces at lists.nsrca.org
> >>  [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Bob
Kane
> >>  Sent: Tuesday, October 17, 2006 9:53 AM
> >>  To: nsrca-discussion at lists.nsrca.org
> >>  Subject: [NSRCA-discussion] Masters 2007 Figure "M" question
> >>
> >>  OK, I'm finally try to fly this thing with a pencil . . . . . .    one
> >>  question I have (so far) is the 1/2 loop between the two stall turns
in
> >the
> >>  figure M: Does it matter if it is an inside or outside half loop?  The
> >>  aresti diagram posted on Flying Giants shows it as an outside half
loop
> >with
> >>  no option.  Thanks.
> >>
> >>  Bob Kane
> >>  getterflash at yahoo.com
> >>
> >>
> >>
> >>  _______________________________________________
> >>  NSRCA-discussion mailing list
> >>  NSRCA-discussion at lists.nsrca.org
> >>  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> >>
> >>  _______________________________________________
> >>  NSRCA-discussion mailing list
> >>  NSRCA-discussion at lists.nsrca.org
> >>  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> >
> >_______________________________________________
> >NSRCA-discussion mailing list
> >NSRCA-discussion at lists.nsrca.org
> >http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
>
> -- 
> ___________
> Jerry Budd
> Budd Engineering
> (661) 722-5669 Voice/Fax
> (661) 435-0358 Cell Phone
> mailto:jerry at buddengineering.com
> http://www.buddengineering.com
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion



More information about the NSRCA-discussion mailing list