[NSRCA-discussion] Masters 2007 Figure "M" question

[jivey61 at bellsouth.net]

New crutch....when flying from left all rolls are left rolls.     When
flying from right all rolls are right rolls.

Jim Ivey
----- Original Message ----- 
From: <jivey61 at bellsouth.net>
To: "NSRCA Mailing List" <nsrca-discussion at lists.nsrca.org>
Sent: Tuesday, October 17, 2006 12:45 PM
Subject: Re: [NSRCA-discussion] Masters 2007 Figure "M" question


> Jerry
>  I looked again at the aresti and I think you are right.The aresti shows
> both upline rolls in the same direction.That would let you see the top one
> time and bottom the other time.
> My mistake Bob so much for crutches.
>
> Jim Ivey
> ----- Original Message ----- 
> From: "Jerry Budd" <jerry at buddengineering.com>
> To: "NSRCA Mailing List" <nsrca-discussion at lists.nsrca.org>
> Sent: Tuesday, October 17, 2006 12:19 PM
> Subject: Re: [NSRCA-discussion] Masters 2007 Figure "M" question
>
>
> > Hi Jim,
> >
> > Unless the maneuver has changed from 15 years ago all the rolls have
> > to be in the same direction, resulting in one stall turn being
> > canopy-facing you and the other being belly-facing you (your choice
> > as to which comes first).  It's a tough maneuver, especially when the
> > wind is blowing other than down the runway.
> >
> > Jerry
> >
> >
> > >Bob
> > >  My memory crutch is,when flying from left to right, the 1st 2 roll
> > >directions are left-left and 2nd 2 roll directions are right-right.
> > >When flying from the right to left,the 1st 2 roll directions are
> right-right
> > >and 2nd 2 roll directions are left-left.
> > >Like Arch said the center half  loop is inverted in both cases.
> > >Lotsa a upside down.
> > >
> > >Jim Ivey
> > >
> > >----- Original Message -----
> > >From: "Archie Stafford" <rcpattern at stx.rr.com>
> > >To: "'NSRCA Mailing List'" <nsrca-discussion at lists.nsrca.org>
> > >Sent: Tuesday, October 17, 2006 11:11 AM
> > >Subject: Re: [NSRCA-discussion] Masters 2007 Figure "M" question
> > >
> > >
> > >>  Bob,
> > >>
> > >>  It has to be inverted.  The direction of roll must be the same on
> every
> > >3/4
> > >>  roll therefore you end up inverted across the middle.
> > >>
> > >>  Arch
> > >>
> > >>  -----Original Message-----
> > >>  From: nsrca-discussion-bounces at lists.nsrca.org
> > >>  [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Bob
> Kane
> > >>  Sent: Tuesday, October 17, 2006 9:53 AM
> > >>  To: nsrca-discussion at lists.nsrca.org
> > >>  Subject: [NSRCA-discussion] Masters 2007 Figure "M" question
> > >>
> > >>  OK, I'm finally try to fly this thing with a pencil . . . . . .
one
> > >>  question I have (so far) is the 1/2 loop between the two stall turns
> in
> > >the
> > >>  figure M: Does it matter if it is an inside or outside half loop?
The
> > >>  aresti diagram posted on Flying Giants shows it as an outside half
> loop
> > >with
> > >>  no option.  Thanks.
> > >>
> > >>  Bob Kane
> > >>  getterflash at yahoo.com
> > >>
> > >>
> > >>
> > >>  _______________________________________________
> > >>  NSRCA-discussion mailing list
> > >>  NSRCA-discussion at lists.nsrca.org
> > >>  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> > >>
> > >>  _______________________________________________
> > >>  NSRCA-discussion mailing list
> > >>  NSRCA-discussion at lists.nsrca.org
> > >>  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> > >
> > >_______________________________________________
> > >NSRCA-discussion mailing list
> > >NSRCA-discussion at lists.nsrca.org
> > >http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> >
> >
> > -- 
> > ___________
> > Jerry Budd
> > Budd Engineering
> > (661) 722-5669 Voice/Fax
> > (661) 435-0358 Cell Phone
> > mailto:jerry at buddengineering.com
> > http://www.buddengineering.com
> > _______________________________________________
> > NSRCA-discussion mailing list
> > NSRCA-discussion at lists.nsrca.org
> > http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion