[NSRCA-discussion] Brio Hinges

[Mark Atwood]

Geek

:)


On 11/13/06 5:00 PM, "Scott Smith" <js.smith at verizon.net> wrote:

> If you go with CA hinges, make up a little jig as shown in the picture to get
> all the slots even.  Once covered,  I use the jig again to cut away the
> covering (that's why it's two sided with the second side a little deeper)  I
> use the GP hinge machine to cut the initial slot then finish it with a #11
> blade.
> 
> 
> 
> -----Original Message-----
> From: nsrca-discussion-bounces at lists.nsrca.org
> [mailto:nsrca-discussion-bounces at lists.nsrca.org]On Behalf Of Richard
> Strickland
> Sent: Monday, November 13, 2006 10:38 AM
> To: 'NSRCA Mailing List'
> Subject: [NSRCA-discussion] Brio Hinges
> 
> 
> 
> What's the best way to hinge beveled surfaces as on the Brio kit?
> 
> Richard
> 
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> 
> 
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20061113/6ef4caf9/attachment.html 
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: image/jpeg
Size: 16693 bytes
Desc: not available
Url : http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20061113/6ef4caf9/attachment.jpe