[NSRCA-discussion] Brio Hinges

[Scott Smith]

If you go with CA hinges, make up a little jig as shown in the picture to
get all the slots even.  Once covered,  I use the jig again to cut away the
covering (that's why it's two sided with the second side a little deeper)  I
use the GP hinge machine to cut the initial slot then finish it with a #11
blade.



-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org]On Behalf Of Richard
Strickland
Sent: Monday, November 13, 2006 10:38 AM
To: 'NSRCA Mailing List'
Subject: [NSRCA-discussion] Brio Hinges



What's the best way to hinge beveled surfaces as on the Brio kit?

Richard

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20061113/81e884e7/attachment-0001.html 
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: image/jpeg
Size: 16693 bytes
Desc: not available
Url : http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20061113/81e884e7/attachment-0001.jpe