[NSRCA-discussion] 4.8 volt Vs 6.0 volt

[Bill Markovitz]

Hi...........Thank you for your input.  I learned a
lot!

.................Bill     :)

--- Bill Markovitz <wdmarko at yahoo.com> wrote:

> Hi all..........I purchased a Quest and a Futaba
> 9CAF
> at the WRAM show.  The 9CAF comes with 3151 digital
> servos rated at 4.3 oz/in.  I would like to use
> these
> servos with the 90 size Quest for competing in the
> Intermediate class and won't be using it for 3D
> flying.  Are these servos adequate for this
> application?  If not, would going to 6 volts give me
> the additonal torque that I need?  How much more
> torque would going to 6 volts give me?  Are there
> any
> known problems using an on-board 6 volt power
> supply? 
> The 9CAF manual states that driving the servos with
> a
> 6 volt supply is an option.
> 
> Thanks.............Bill       :)
> 
> __________________________________________________
> Do You Yahoo!?
> Tired of spam?  Yahoo! Mail has the best spam
> protection around 
> http://mail.yahoo.com 
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
>
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> 


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com