[NSRCA-discussion] Help: Elevator Setup on JR10X

[ronclark51 at comcast.net]

I had the same problem with that setup. I finally went to a servo reverser on one servo and used just the elevator channel.

-------------- Original message -------------- 
From: "Dave Michael" <davidmichael1 at comcast.net> 

> All, 
> 
> I am setting up a new plane using the wing type mix (22) for an elevator 
> servo on each half, plugging into the elevator and AUX3 ports as instructed. 
> 
> Using the stick on each of the elevators coming together at a single point 
> behind the rudder to check tracking. I am finding that the elevators are 
> aligned at center and at full up and down elevator. 
> 
> I am also finding that the elevator on AUX 3 starts earlier and reaches full 
> throw earlier than the other elevator and thus tracks with greater throw on 
> that half than on the other half anywhere between neutral and full throw. 
> This is happening with up elevator only- not down elevator. 
> 
> I am hoping I can set up some sort of curve one one half or the other so 
> that I can match the two elevators perfectly (well, as perfectly as 
> possible). Has anyone done this and what are the steps? 
> 
> Thanks, 
> 
> Dave Michael 
> 
> _______________________________________________ 
> NSRCA-discussion mailing list 
> NSRCA-discussion at lists.nsrca.org 
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20060601/4635b328/attachment.html