<html><body>
<DIV>I had the same problem with that setup. I finally went to a servo reverser on one servo and used just the elevator channel.</DIV>
<DIV> </DIV>
<BLOCKQUOTE style="PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #1010ff 2px solid">-------------- Original message -------------- <BR>From: "Dave Michael" <davidmichael1@comcast.net> <BR><BR>> All, <BR>> <BR>> I am setting up a new plane using the wing type mix (22) for an elevator <BR>> servo on each half, plugging into the elevator and AUX3 ports as instructed. <BR>> <BR>> Using the stick on each of the elevators coming together at a single point <BR>> behind the rudder to check tracking. I am finding that the elevators are <BR>> aligned at center and at full up and down elevator. <BR>> <BR>> I am also finding that the elevator on AUX 3 starts earlier and reaches full <BR>> throw earlier than the other elevator and thus tracks with greater throw on <BR>> that half than on the other half anywhere between neutral and full throw. <BR>> This is happening with up elevator only- not down elevator. <BR>> <BR>> I am hoping I can set
up some sort of curve one one half or the other so <BR>> that I can match the two elevators perfectly (well, as perfectly as <BR>> possible). Has anyone done this and what are the steps? <BR>> <BR>> Thanks, <BR>> <BR>> Dave Michael <BR>> <BR>> _______________________________________________ <BR>> NSRCA-discussion mailing list <BR>> NSRCA-discussion@lists.nsrca.org <BR>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion </BLOCKQUOTE></body></html>