[NSRCA-discussion] Twin elevator servo issue using Futaba 9 ZAP

[Bob Richards]

That might be the cause, or it could simply be a difference in linearity between the servos.
   
  Bob R.
  

jivey61 at bellsouth.net wrote:
  Peter
What causes this to happen is the location of the pushrod connections at the
elevators hinge points.One is not the same distance to the hinge line as the
other. Or the distance to the hinge line from the clevis's is not the same.
You corrected for the difference at max throw,but the tracking is off in
between.
Have a looksee.

Jim Ivey
----- Original Message ----- 
From: "Peter Pennisi" 

To: "'NSRCA Mailing List'" 
Sent: Thursday, August 10, 2006 10:05 AM
Subject: [NSRCA-discussion] Twin elevator servo issue using Futaba 9 ZAP


>
> I am using a twin elevator setup (for the first time) in my current F3A
> bird. I am having some servo tracking issues which I can't resolve. All
end-
> points and sub-trims have been adjusted perfectly however when I place
some
> long extension pins (6 inches) on my elevator halves directed back to the
> centre of my rudder I notice one side leads while the other lags. At half
> elevator stick the throws are different but the end points line up
> perfectly.
>
> What are you guys doing to get this exact (if you can?)
>
> I have one channel plugged into the elevator channel while the other is in
> the gear channel. I am using the Ailevators function on the radio and
> configured as suggested.
>
>
> Thanks
>
> Peter
>
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20060810/67484918/attachment-0001.html