<div>That might be the cause, or it could simply be a difference in linearity between the servos.</div> <div> </div> <div>Bob R.</div> <div><BR><BR><B><I>jivey61@bellsouth.net</I></B> wrote:</div> <BLOCKQUOTE class=replbq style="PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #1010ff 2px solid">Peter<BR>What causes this to happen is the location of the pushrod connections at the<BR>elevators hinge points.One is not the same distance to the hinge line as the<BR>other. Or the distance to the hinge line from the clevis's is not the same.<BR>You corrected for the difference at max throw,but the tracking is off in<BR>between.<BR>Have a looksee.<BR><BR>Jim Ivey<BR>----- Original Message ----- <BR>From: "Peter Pennisi" <PENTAGON.SYSTEMS@BIGPOND.COM><BR>To: "'NSRCA Mailing List'" <NSRCA-DISCUSSION@LISTS.NSRCA.ORG><BR>Sent: Thursday, August 10, 2006 10:05 AM<BR>Subject: [NSRCA-discussion] Twin elevator servo issue using Futaba 9 ZAP<BR><BR><BR>><BR>> I am using a
twin elevator setup (for the first time) in my current F3A<BR>> bird. I am having some servo tracking issues which I can't resolve. All<BR>end-<BR>> points and sub-trims have been adjusted perfectly however when I place<BR>some<BR>> long extension pins (6 inches) on my elevator halves directed back to the<BR>> centre of my rudder I notice one side leads while the other lags. At half<BR>> elevator stick the throws are different but the end points line up<BR>> perfectly.<BR>><BR>> What are you guys doing to get this exact (if you can?)<BR>><BR>> I have one channel plugged into the elevator channel while the other is in<BR>> the gear channel. I am using the Ailevators function on the radio and<BR>> configured as suggested.<BR>><BR>><BR>> Thanks<BR>><BR>> Peter<BR>><BR>><BR>> _______________________________________________<BR>> NSRCA-discussion mailing list<BR>> NSRCA-discussion@lists.nsrca.org<BR>>
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion<BR><BR>_______________________________________________<BR>NSRCA-discussion mailing list<BR>NSRCA-discussion@lists.nsrca.org<BR>http://lists.nsrca.org/mailman/listinfo/nsrca-discussion<BR></BLOCKQUOTE><BR>