DZ 140

[Jim Ivey]

Don
 I use a 16.5x12W and get 82-8500. Needle will peak about 1 1/4 turns but use a tach here. I go to the max rpm and back off 200 rpm. Don't need all of it anyway.

Jim Ivey
> 
> From: Donald Filteau <don.filteau at sasktel.net>
> Date: 2005/05/17 Tue PM 07:47:51 EDT
> To: discussion at nsrca.org,  discussion at nsrca.org
> Subject: DZ 140
> 
> Hi People
> 
> I just got a new 140 DZ  I tried to run the engine on a 16.5 X 15W APC.  It would only run 7500 rpm.  I us 25% fuel.  ATT. 1800 above sea level.  TEMP 70 F.  Then tried a 15.5 X 14W.  I got 8500 rpms.  Did not get off the ground to tried the engine.  To windy 40 KM.  What should a persons try for props.  and what settings.  Then needle setting was about one and half turns out.
> 
> Thank
> Don Filteau
> Prince Albert Canada
> 
> 
> 
> =================================================
> To access the email archives for this list, go to
> http://lists.f3a.us/pipermail/nsrca-discussion/
> To be removed from this list, go to http://www.nsrca.org/discussionA.htm
> and follow the instructions.
> 
> List members email returned for mailbox full will be removed from the list.
> 
> 

=================================================
To access the email archives for this list, go to
http://lists.f3a.us/pipermail/nsrca-discussion/
To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.

List members email returned for mailbox full will be removed from the list.