Webra 1.45 remote glow

[Ed Miller]

On my Mintor head OS 140RX, Dave and I also removed the anodize finish from 
the glow plug seating area of the glow plug that the remote glow clip was 
attached to.
Ed M.
----- Original Message ----- 
From: "David Lockhart" <DaveL322 at comcast.net>
To: <discussion at nsrca.org>
Sent: Monday, May 16, 2005 9:18 PM
Subject: Re: Webra 1.45 remote glow


> Dave,
>
> What I did -
>
> - Remove the sleeve from the engine.
> - 3M-77 some 600 grit paper to the top of the sleeve.
> - trim the sandpaper to match the OD of the sleeve.
> - you now have the proper tool to remove the anodizing on the head where 
> it
> contacts the sleeve.
> - use a little bit of oil and be careful to use even pressure.
>
> With the anodizing removed from the head where it contacts the sleeve, the
> remote glow will work fine.
>
> Dave
>
> ----- Original Message -----
> From: "David Wartel" <d.wartel at comcast.net>
> To: <discussion at nsrca.org>
> Sent: Monday, May 16, 2005 10:14 PM
> Subject: Webra 1.45 remote glow
>
>
>> I'm trying to install a remote glow plug on a Webra 1.45. The head seems
> to
>> be insulated from the crank case so the ground does not work when
> connected
>> to a mount lug bolt. The remote works when the plug is touched to the
> crank
>> case, or when the ground is touched to the head. I don't see a way to
>> connect the ground to the head.
>>
>> Anyone have suggestions?
>>
>> Thanks, Dave
>>
>>
>> =================================================
>> To access the email archives for this list, go to
>> http://lists.f3a.us/pipermail/nsrca-discussion/
>> To be removed from this list, go to http://www.nsrca.org/discussionA.htm
>> and follow the instructions.
>>
>> List members email returned for mailbox full will be removed from the
> list.
>>
>
> =================================================
> To access the email archives for this list, go to
> http://lists.f3a.us/pipermail/nsrca-discussion/
> To be removed from this list, go to http://www.nsrca.org/discussionA.htm
> and follow the instructions.
>
> List members email returned for mailbox full will be removed from the 
> list.
> 

=================================================
To access the email archives for this list, go to
http://lists.f3a.us/pipermail/nsrca-discussion/
To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.

List members email returned for mailbox full will be removed from the list.