[SPAM] Re: dual elevator servos

[jjvoth]

I'll be using either a JR PCM 10 (old) or a JR 8103. When the stick is moved quickly on the 10, one servo lags. I havn't tried the 8103 and am not sure if it will work with dual elevator servos.

Jerry
  ----- Original Message ----- 
  From: Ed Alt 
  To: discussion at nsrca.org 
  Sent: Saturday, May 14, 2005 10:50 PM
  Subject: [SPAM] Re: dual elevator servos


  Your best bet is using separate channels with a mix.  With a Y setup, you will deprive yourself of the fine tuning capability you will need to make the travels correct, unless you get lucky with a perfectly matched set of servos out of the box.  A Matchbox will work fine, but you're adding weight, cost and an extra point of failure, however unlikely it is that one will fail.  If you use a mix, not only can you duplicate the Matchbox capability, you can exceed it if you have a multi-point mix capability on your radio.  A Matchbox is good for center and end points and that's it.

  Ed
    ----- Original Message ----- 
    From: jjvoth 
    To: discussion at nsrca.org 
    Sent: Saturday, May 14, 2005 11:33 PM
    Subject: dual elevator servos


    I want to use dual elevator servos. Will a Y harness with a matchbox work or do I have to use two channels? The servos have to be about 1.2" in length. What is the best JR or Hitech servo to use?

    TIA

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20050515/14a9a08a/attachment.html