THROTTLE SERVO

[rcaerobob at cox.net]

Mount a HS-55 to the engine beam itself, using a short, solid link direct to the carb arm.  Pics on my site.  Lasts forever.
> 
> From: "Wayne Galligan" <wgalligan at goodsonacura.com>
> Date: 2005/03/22 Tue PM 03:44:37 EST
> To: <discussion at nsrca.org>
> Subject: THROTTLE SERVO
> 
> I have been running a HiTec 85MGBB  for my throttle servo.  I have had to
> replace this servo about 3 times in the last 2.5 yrs.   I have seen many
> people run this servo or one this size in the open engine bay and was
> wondering what kind of life you are getting out of your servo's.   When mine
> go bad its in the mid-range or center the throttle will surge and sometimes
> it will make the elevator twitch when this happens.    I am going to make a
> plate and recess the servo out of the engine bay to eliminate the heat and
> fuel.   Could it be vibration at this throttle point could be effecting the
> pot in the servo...???
> 
> 
> Wayne Galligan
> 
> 
> =================================================
> To access the email archives for this list, go to
> http://lists.f3a.us/pipermail/nsrca-discussion/
> To be removed from this list, go to http://www.nsrca.org/discussionA.htm
> and follow the instructions.
> 
> 

Bob Pastorello, El Reno, OK, USA
rcaerobob at cox.net
www.rcaerobats.net

=================================================
To access the email archives for this list, go to
http://lists.f3a.us/pipermail/nsrca-discussion/
To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.