Sat Jun 18 17:18:05 AKDT 2005

When it's good and tight, hit the end of the puller screw a good belt
with a hammer! The abrupt shock will bust it free.

David Wartel wrote:

> I'm replacing the bearing in a Webra 1.45. All of the "difficult"
> disassembly is done: the circlip, wrist pin etc., but I'm having
> trouble removing the prop drive hub. I'm assuming this is a press fit
> and am using a gear puller, but even tightening the tool as much as I
> can, the hub stays put. Is there a trick to removing it? Thanks, Dave
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20050619/a56d3d8d/attachment.html