(no subject)

[David Wartel]

I'm replacing the bearing in a Webra 1.45. All of the "difficult" disassembly is done: the circlip, wrist pin etc., but I'm having trouble removing the prop drive hub. I'm assuming this is a press fit and am using a gear puller, but even tightening the tool as much as I can, the hub stays put. 

Is there a trick to removing it?

Thanks, Dave
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20050619/c04da44b/attachment.html