[David Wartel]

I hope you're joking! I just emailed a friend about this and he said, "take your time and think things through before you resort to a hammer." (!)

Also: I'm using the Boca sealed SS bearing. What was the concensus regarding leaving/removing the seal(s)?

Dave
  ----- Original Message ----- 
  From: george kennie 
  To: discussion at nsrca.org 
  Sent: Saturday, June 18, 2005 9:17 PM
  Subject: Re: 


  When it's good and tight, hit the end of the puller screw a good belt with a hammer! The abrupt shock will bust it free. 
  David Wartel wrote: 

    I'm replacing the bearing in a Webra 1.45. All of the "difficult" disassembly is done: the circlip, wrist pin etc., but I'm having trouble removing the prop drive hub. I'm assuming this is a press fit and am using a gear puller, but even tightening the tool as much as I can, the hub stays put. Is there a trick to removing it? Thanks, Dave
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20050619/15648ed4/attachment.html