9411SA geartrain tick

[Grow Pattern]

 Ed,
       I had a couple of 9411's that I made into SA's with the plastic gear 
sets. Output shaft still ali - that's another story :-(

They clicked. I found some mold flashings on the top of  the "plastic" gears 
that I removed with the scraping action of a razor blade.

Eric.

>> I haven't had that problem. Was that with the servo arm on and tight or 
>> was it without the servo arm. Does it stop clicking with the arm tight? 
>> That will tend to pull the output shaft up out of the servo and maybe 
>> relieve the clicking.
>>
>> Jim Ivey
>>>
>>> From: "Ed  Alt" <ed_alt at hotmail.com>
>>> Date: 2005/07/05 Tue PM 10:02:49 EDT
>>> To: <discussion at nsrca.org>
>>> Subject: 9411SA geartrain tick
>>>
>>>
>>
>> =================================================
>> To access the email archives for this list, go to
>> http://lists.f3a.us/pipermail/nsrca-discussion/
>> To be removed from this list, go to http://www.nsrca.org/discussionA.htm
>> and follow the instructions.
>>
>> List members email returned for mailbox full will be removed from the 
>> list.
>>
>>
> =================================================
> To access the email archives for this list, go to
> http://lists.f3a.us/pipermail/nsrca-discussion/
> To be removed from this list, go to http://www.nsrca.org/discussionA.htm
> and follow the instructions.
>
> List members email returned for mailbox full will be removed from the 
> list.
> 

=================================================
To access the email archives for this list, go to
http://lists.f3a.us/pipermail/nsrca-discussion/
To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.

List members email returned for mailbox full will be removed from the list.