Futaba 8UA

[Wayne Galligan]

Thanks Troy....   I think you may have answered my question.   I recently
install a new gimbal because the spring retainer pin broke.  I bet I just
need to adjust the pot.   If not then I know you suggestion may be the
problem.

Thanks

Wayne
----- Original Message ----- 
From: "Troy A. Newman" <troy_newman at msn.com>
To: <discussion at nsrca.org>
Sent: Friday, January 07, 2005 5:56 PM
Subject: Re: Futaba 8UA


> Wayne,
>
> Look to getting the TX serviced. The TX pots are worn or have slipped.
This
> is a pretty common deal. If your TX has a couple years on it its time for
> new TX gimbal pots. I used to fly the Futaba 9Z and same problem with the
> pots were worn.
>
>
> TN
> ----- Original Message ----- 
> From: "Wayne Galligan" <wgalligan at goodsonacura.com>
> To: <discussion at nsrca.org>
> Sent: Friday, January 07, 2005 4:53 PM
> Subject: Futaba 8UA
>
>
> > I have a problem with dual elevator control.
> >
> > I am using the Ailevator mode for dual elevator servo's on my Funtana.
> The
> > problem is when I switch from D/R high to low a small amount of up trim
> > kicks in on both servo's.  I cant seem to find any thing in both the
> factory
> > manual or the aftermarket manual on this issue.
> > Hopefully all you radio guru's have an answer to my dilemma.
> >
> > Thanks
> >
> > Wayne Galligan
> >
> >
> > =================================================
> > To access the email archives for this list, go to
> > http://lists.f3a.us/pipermail/nsrca-discussion/
> > To be removed from this list, go to http://www.nsrca.org/discussionA.htm
> > and follow the instructions.
> >
> >
> =================================================
> To access the email archives for this list, go to
> http://lists.f3a.us/pipermail/nsrca-discussion/
> To be removed from this list, go to http://www.nsrca.org/discussionA.htm
> and follow the instructions.
>
>


=================================================
To access the email archives for this list, go to
http://lists.f3a.us/pipermail/nsrca-discussion/
To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.