[NSRCA-discussion] securing servo wires

[jivey61 at bellsouth.net]

David
 I bundle the wires in a nice bundle about 1/2 inch from the receiver and
use a small tye-rap. If one comes out they all come out, however this isn't
likely to happen.

Jim Ivey
----- Original Message ----- 
From: "David Flynt" <dflynt at verizon.net>
To: <nsrca-discussion at lists.nsrca.org>
Sent: Wednesday, December 14, 2005 10:51 PM
Subject: [NSRCA-discussion] securing servo wires


> Can anybody suggest a good way to help prevent servo wires from pulling
out
> of a receiver?  I have never paid attention to this, and never really had
a
> problem except one time one of my elevator servo wires pulled loose.  I
was
> fortunate to have half an elevator remaining and enough control to land.
> But now I only use a single elevator servo.
>
> I typically use either JR r770 or r649 receivers.
>
> Any ideas would be appreciated.
>
> Thanks,
>
> David Flynt
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion