[NSRCA-discussion] securing servo wires

[Ken Thompson]

David,

I usually fold the wires down over the top of my receiver and secure them 
with a rubber band, around the receiver and wires, fairly snug.
Make sure you leave enough wire so as not to bind the wire against the 
connector.
Install as usual, sounds simple but it works for me.

Ken
----- Original Message ----- 
From: "David Flynt" <dflynt at verizon.net>
To: <nsrca-discussion at lists.nsrca.org>
Sent: Wednesday, December 14, 2005 10:51 PM
Subject: [NSRCA-discussion] securing servo wires


> Can anybody suggest a good way to help prevent servo wires from pulling 
> out
> of a receiver?  I have never paid attention to this, and never really had 
> a
> problem except one time one of my elevator servo wires pulled loose.  I 
> was
> fortunate to have half an elevator remaining and enough control to land.
> But now I only use a single elevator servo.
>
> I typically use either JR r770 or r649 receivers.
>
> Any ideas would be appreciated.
>
> Thanks,
>
> David Flynt
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion