Futaba WCII battery jumper pin placement

[Dave Reaville]

Thanks for the quick reply Dean

If you can please send me the jpg directly at patternwestnews at shaw.ca I would be most appreciative.

Dave


  ----- Original Message ----- 
  From: Dean Pappas 
  To: discussion at nsrca.org 
  Sent: Monday, August 15, 2005 12:53 PM
  Subject: RE: Futaba WCII battery jumper pin placement


  Hi Dave,
  Ron Ellis reverse engineered it a million years ago, and the JPG is too large for this forum.
  The + terminal is on pins 2 and 3. The negative terminal is on pins 4 and 5. 
  You could also go look up the directions on the Sirius Charger site to modify the pack 
  so that you can cycle and fast charge through the existing connector.
  Dean

  Dean Pappas 
  Sr. Design Engineer 
  Kodeos Communications 
  111 Corporate Blvd. 
  South Plainfield, N.J. 07080 
  (908) 222-7817 phone 
  (908) 222-2392 fax 
  d.pappas at kodeos.com 

    -----Original Message-----
    From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]On Behalf Of Dave Reaville
    Sent: Monday, August 15, 2005 3:42 PM
    To: discussion at nsrca
    Subject: Futaba WCII battery jumper pin placement


    Hi Folks

    Can anyone please tell me what two holes in the Futaba WCII battery (when taken out of the TX) must be connected (pinned) to allow for cycling (discharge) of the battery pack? I don't have the fancy HSP78050 thingamajig :-)

    Thanks,

    Dave

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20050815/e4827bf5/attachment.html