DZ 160 New Start up problem

[Ronald Filteau]

Thank folks.  I did turn the prop over a few time before trying to start it just like my 140L.
My have caused the problem.  I will give the ideas a try today.

Ron
  ----- Original Message ----- 
  From: William Ahrens 
  To: discussion at nsrca.org 
  Sent: Sunday, August 07, 2005 8:08 AM
  Subject: RE: DZ 160 New Start up problem


  Ron

  Good its getting fuel, just make sure its not flooding.  I would next check the valve gap by removing the black cover,  they should have a slight gap at top dead center timing. 

  Then make adjustments to needle as I said before. 

  Bill A.




------------------------------------------------------------------------------

  From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org] On Behalf Of Ronald Filteau
  Sent: Saturday, August 06, 2005 11:58 PM
  To: discussion at nsrca.org
  Subject: Re: DZ 160 New Start up problem



  I am using 25% and a Hatiro pipe and NMP header set up.  Fuel is getting to the high end needle.



  Ron

    ----- Original Message ----- 

    From: William Ahrens 

    To: discussion at nsrca.org 

    Sent: Saturday, August 06, 2005 10:30 PM

    Subject: RE: DZ 160 New Start up problem




    Ron

    You did not mention what fuel, pipe setup.

    But, verify tank is vented and fuel can be pulled, Regulator set flush to a little out.  Needle at about 1 ¾.   Cool power 30% Heli.  And it will run.

    Bill A.




----------------------------------------------------------------------------

    From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org] On Behalf Of Ronald Filteau
    Sent: Saturday, August 06, 2005 11:23 PM
    To: NSRCA Pattern List
    Subject: DZ 160 New Start up problem



    Hi Folks



    Just got my first 160 DZ.  I have been trying to start it for the first time.  All it is doing is back firing.  The needle is 2 two out like the instruction states.  What should I do to get it to start.



    Ron
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20050807/164a3ec6/attachment.html