DZ 160 New Start up problem

[William Ahrens]

Ron

Good its getting fuel, just make sure its not flooding.  I would next check
the valve gap by removing the black cover,  they should have a slight gap at
top dead center timing. 

Then make adjustments to needle as I said before. 

Bill A.

 

  _____  

From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org] On
Behalf Of Ronald Filteau
Sent: Saturday, August 06, 2005 11:58 PM
To: discussion at nsrca.org
Subject: Re: DZ 160 New Start up problem

 

I am using 25% and a Hatiro pipe and NMP header set up.  Fuel is getting to
the high end needle.

 

Ron

----- Original Message ----- 

From: William Ahrens <mailto:ahrensw at charter.net>  

To: discussion at nsrca.org 

Sent: Saturday, August 06, 2005 10:30 PM

Subject: RE: DZ 160 New Start up problem

 


Ron

You did not mention what fuel, pipe setup.

But, verify tank is vented and fuel can be pulled, Regulator set flush to a
little out.  Needle at about 1 ¾.   Cool power 30% Heli.  And it will run.

Bill A.

 


  _____  


From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org] On
Behalf Of Ronald Filteau
Sent: Saturday, August 06, 2005 11:23 PM
To: NSRCA Pattern List
Subject: DZ 160 New Start up problem

 

Hi Folks

 

Just got my first 160 DZ.  I have been trying to start it for the first
time.  All it is doing is back firing.  The needle is 2 two out like the
instruction states.  What should I do to get it to start.

 

Ron

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20050807/82e475b6/attachment.html